Skip to main content
How can we help?

Welcome to our Support Portal. Search for answers using the search box below, or create a support ticket if you cannot find your answer.

< All Topics
Print
Posted
Updated
ByAdmin-LS
0 out of 5 stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
Views357

This is a quick step-by-step guide on wiring a plastic BC lampholder.

  • Bottom Section (Cap)

  • Connection Unit

  • Cord Grip

     

Lorem ipsum, or lipsum as it is sometimes known, is dummy text used in laying out print, graphic or web designs.

Step 1

Take the base (cap) of the lampholder and screw it onto the fixing point.

Next, feed the cable through the hole carefully, ensuring not to damage it as you push/pull it through.

Make sure you leave this loose so you can adjust the length when on step 4.

 

Step 2

Slide the cord grip down the cable (roughly half an inch from the top). This will prevent the cable from being pulled out the lampholder by accident.

 

Step 3

Wire the cable into the connection unit of the lampholder.

This is done by firstly loosening the screws in the connection unit, then inserting the cable ends into the connection points, it does not matter which way around the Live (Brown) and Neutral (Blue) go.

Lastly, re-tighten the screws, so the cable is securely in place, as shown in the image below.

 

Step 4

Finally, screw the connection unit and the base of the lampholder together.

Was this article helpful?
0 out of 5 stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
5
Please Share Your Feedback
How Can We Improve This Article?
Scroll to Top