Skip to main content
How can we help?

Welcome to our Support Portal. Search for answers using the search box below, or create a support ticket if you cannot find your answer.

< All Topics
Print
Posted
Updated
ByAdmin-LS
0 out of 5 stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
Views133

This is to show you a step by step guide on how to install Kit 1.

In this guide I have used all parts that you get from Kit 1 and installing them onto a wooden block that I have already pre-drilled a hole in.

Step 1

Feed the cable cord set through your light fitting ensuring not to damage it as you push/pull it through. Ensure you leave this loose so you can adjust the length when on step 3.

Next, place the backplate over the cable and fix it down onto your wooden lamp using the supplied screws, then place the cover over the top.

Step 2

Separate the lampholder into its 3 pieces by unscrewing the shade ring and lock ring, leaving you with the cap, the connection unit and the skirt.

Then take the cap of the lampholder and screw it onto the thread of the backplate.

Step 3

Using a pair of pliers, double over the ends of the cable.

Next, wire the cable into the connection unit of the lampholder. This is done by firstly loosening the screws in the connection unit, then inserting the cable ends into the connection points, ensuring the Earth (Green/Yellow) is in the middle connection.

It does not matter which way around the Live (Brown) and Neutral (Blue) go. Lastly, retighten the screws, so the cable is securely in place, as shown in the image below.

Step 4

Carefully push the connection unit into the cap of the lampholder and place the top section (the skirt) onto the lampholder, ensuring the indents line up.

Finally, screw the lock ring and shade ring onto the lampholder.

Note: The copper tag is to sit over the indent on the lampholder so it is slightly visible.

Step 5

Carefully push the connection unit into the cap of the lampholder and place the top section (the skirt) onto the lampholder, ensuring the indents line up.

Finally, screw the lock ring and shade ring onto the lampholder.

Note: The copper tag is to sit over the indent on the lampholder so it is slightly visible.

Download Instruction Leaflet
Was this article helpful?
0 out of 5 stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
5
Please Share Your Feedback
How Can We Improve This Article?
Tags:
Scroll to Top